I have been working on the veneer piece that I mentioned earlier.
The purpose of the is piece is to border the perimeters of the Fillport, Exhaust Fan, Fan controllers, and the Power Switch as a single unified piece.
If my calculations are correct the can controller knobs will be recessed by about 5mm. There will a round-over on both the inside and the outside of the top. This will ease the access to the fan control knobs, and ease the edge so that it is not so harsh. One of the main purposes of this piece is to quasi-stealth the knobs....
The following series of pics shows the original plan, what I actually cut, and then a test-fit over the top panel of the case itself.
The fillport is in the upper left-hand corner, and the power switch front-and-center.
There is a considerable amount of sanding to be done before I can take the router-bit to it. I also need to round the small nubs that are on either end of the "spars".... but I need a break from that piece...
Tomorrow is carbon fiber fabrication day.
