Ok guys well i tried out drilling the holes through the support and it worked out quite well but i noticed if you drill all the way through you will chip the side that the drill comes through whereas if you drill most the way through so that the drill is just poking through then turn over and drill the other way you dont chip it.
I then decided to move on to the next module.... so here goes
step by step :
1. i mark out the piece that will be bent
2. then cut it out
3. then grab your 30"bending brake
4. mark where you want it bent
5. start bending untill you think its about right
6. grab your set square with a handy 45degree angle on it
7. check angle its not quite right just bend some more and if its too bent then just push it back with your hand.
8. repeat stages 4-7
and that is it for today guys.
hope you enjoyed it
Josh