Day 8
since my last update, i've take apart my loop and cleaned them again and re did the layout for the pumps. it should work out better this time with the tubes not as restricted at some points. and this time you can see the res-top pump closer now! i've relocated the cathodes to their original positions and found out that i was using the wrong inverter. i had two. one for two 4 inchers and one for the two 12 inchers. you can guess which one i was using when i took the picture. haha. in anycase (no pun intended), it should work and look better than before.
i'm also receiving my gpu block back from petras, after one of my screws broke, tomorrow. that i'm still waiting on an rma for my 8800gt for my sig rig. i've ordered some new tubing too cause i've realized that i need more than i have.
enough chit-chat. on with the show! ok, so i made some time to do a bit of the side panel. here it is taped and measured out for the cutting.
here is the mirror acrylic taped and measured for cutting too.
4 holes since i want the acrylic to have round edges to follow suit of the case. i'll be using small bolts and nuts to attach the acrylic. there will be no u channel so... hehe, i can't screw up at all. ;D i don't have picture right now but i actually cut the acrylic already and sanded the side down so its straight and smooth. as you can see in this picture, i have one side of the panel cut... BUT, as i was cutting the opposite side, my dremel decided to die on me.
so its time for a new dremel.
the side panel should be done by the end of this weekend.
* This Worklog post was generated using WorklogCreator - Version: 1.0.0.5
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip