Hello again.
Lookee at my almost-level and none-too stable work table:
Lol! (Nelson, “Ha-Ha)”
I have become quite fond of this gimmicky Dremel vice… turns out “gimmicky” is “good” *eats crow*
Here are the rough-cut motherboard support pieces (or more accurately. “some of them”):
These pieces were rip-fences that I made for the router table, but I don’t use them. Instead, I put them to use as the rails for the motherboard to slide in and out of the case on. One will be mounted to the inside top of the case, and the other on a shelf.
Like so…
…with the optical drive up front (but enclosed in its housing).
Here are a few different shots of a test-fit:
The next image shows the manner in which the motherboard support/optical drive housing will bisect the Y-axis of the case. On each side will be one of the 480 radiators.
I still need to dismantle the panels and put a finishing polish on them before I can start assembling the insides of the case.
