... lets see if I can nudge this thread in the right direction...
After spending a fair amount of time on the CF angle hardware runners, I needed to think about something else: The HDD cage and the PSU trays and slide-systems.
Here are the raw panels:
Panels grooved and then cut to size. The smaller pieces will be the end-caps (stops).
These are the CF angle hardware runners. They are almost done, but a final polish will be required:
One of the top-panel runners was too long to fit alongside the top bezel so I needed to cut it down and shape it to fit:
Here are the completed CCL end-caps:
Tonight or tomorrow morning I will start the final assembly of the main panels.
