Top-side exhaust fan installation.
The primary exhaust fan need some attention. I sleeved the cable, and removed the molex connector. The molex connector will be replaced with a 3-pin power connector as I they are smaller and less obtrusive than the awkward and larger molex connectors.
The grillwork tabs needed to get a small felt pad to prevent marring of the acrylic and to eliminate any vibration that might occur:
Fan mounted, and the top motherboard rail set in place to check for fitment:
Today I will continue sanding a polishing the HDD and PSU tray/rail systems, I should be mounting them tonight.
Then, it is back to the lighting.
