The Intelligence - Day 24
so I sanded for a couple hours, thats the various grits I was using (boring)
after that I was up for some electrical work
at one point I was going to cut the wire down, but the cautious side of me took over
my humble electrical kit
the extension plug clamped down for wire pulling under heat
cleared of debris
started to shrink and sleeve in red
ready for connecting to the plug
wrapped
ugly soldering, consider it a functional mod
ready to hide the ugliness
shrinked each line
sild up the wider shrink and heat gunned it too
continuity tested each of the three lines, all ok
test fit...
bendy...
(notice the piece of electrical tape, the sleeve started to unwind and fray from the shrink. I may redo this piece entirely in shrink, but we'll see, for now I left it alone
I think it looks cool tho
needed to trim off the lower mobo pan lip since I am not using the holes for mounting, and it creates a bad gap behind the case
sliced!
rough cuts
test fit...
some filing and sanding
needed to fill some pinholes
I am starting to hate this stuff, but I love it at the same time
5 mins later, alien abortion
(forgot to pic the case part that I refilled, sorry)
did some more spot priming on the parts I spent two hours sanding at the top of this log. i think I am nearly there
Well thats all for now folks, hope you enjoyed
more tomr. thanks for watching
I also epicly ruined the hinges by spraying clear on them (was 24 hours wait tho), so they will need an acetone bath and a scrub down, and then a repainting - I am actually happy about it
* This Worklog post was generated using WorklogCreator - Version: 1.0.0.7
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip