Here is the donor for the expansion slot and I/O block frame.
I was very careful while drilling the rivets out as I want the entire unit to remain serviceable, and a mangled hunk of aluminium does not meet the criteria. Here is what I was after:
Fan Controllers
Zalman MFC-1
No faceplate needed:
Mounted in the case (test fit):
I need to re-make a couple of the mounting blocks (casualties from previously described drilling FUBAR), but that will have to wait until tomorrow.
I have already cut the rear panel, so next is to drill the holes in the motherboard tray for the stand-offs.
Thanks for taking a gander.
