Day 5
hello again! today, i took apart the case. well most of it. anyway.
here are the rail guides. all six of them.
there here are the rails themselves.
and the motherboard, center divider, and bay drive holder still in tact. question is, should i take it apart and get it powdered individually or powdered all together as it is?
and here is the bare case. i need to start cutting holes into for the exhaust.
i'm actually doing some drilling and cutting today. well more drilling than anything. the zalman fan controller front clamped to my bay drive panel.
after the drilling. looks good to me!
antd here it is and how it would look with the knobs on top but then realized that i actually drilled the holes on the wrong half!
but its ok, i just took another drive bay and redid it and here it is how it looks. though actually they are both the last one just flipped upside down.
not sure which orientation i want but i think i want it on the bottom.
and here is my altered scythe kaze master. i cut off all four knobs as i won't be using them. this is purely for information on my pumps and water temps going through the tubing. i got rid of the flimsy cover and i think it look really good just bare metal. but i need to get another one made w/o the holes so i can just put it in my drive bay.
so the three questions i have today are!
1.) should i take apart the mobo/bay holder for powdering (all same color:white)
2.)should i powder my bay drives black while the rest of the case is midnight blue(rad is black already and i'm leaving them as is)?
3.)what color blackfire fans should i use inside (1x 120mm, 2x 80mm)?
* This Worklog post was generated using WorklogCreator - Version: 1.0.0.7
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip