Alright, an update!
Day 16 - Top Panel part 3
Well, today I mostly worked on the top panel and placed more epoxy on the fan holes. I went ahead and began cutting the excess acrylic I had around the top panel cut.
Cutting the Acrylic was divided into 2 phases.
Phase one, preparing the acrylic to be marked for cut.
The acrylic ready to be cut.
One down.
Two down.
Three down!
Placed under the panel, flawless (almost) fit, moving now to phase two, which is to make it fit and file the edges.
Now, placed on top ready to be marked.
Phase two: And.... done. Marked those two corners.
Both cut!
Once again, in place, after being cut.
It'll roughly look like this
Here I marked where the M4 Hex screws will be placed to hold the acrylic. I still am going to round out those corners on the top right.
In the process the epoxy is now solid enough, next time I will cover the 3rd fan hole and drill the holes for the hex screws.
Thanks for watching!
