CattleRustler

Tech Bench - Day 03 - side panel screw holes

thats the 24x24" sheet of transparent grey cast acrylic from mcmaster. The panel isnt scratched, there was some tape holding down some flat steel bar (for Butcher's Hook project) that tore some of the paper backer more on this tomr

laid out the left side panel and marked off for the screw drill outs

doing both sides with 4 across the bottom, and three in the mid section

did the same to the right panel

decided to go brave and just placed a fan over the fan hole , and passed the drill bit thru the fan frame to score the drill points. then I removed the fan and drilled out the holes 7/64



I did the same on both panels, then over-bored the 8 fan screw holes to 9/64 to let some 6-32 black oxides pass thru when the time comes

tomr will be a mix of work on this and work on the Butcher's Hook project too

thanks for watching



* This Worklog post was generated using WorklogCreator - Version: 1.0.1.5
* Free Download: http://www.mod2software.com/worklogc...logcreator.zip

__________________

[Current Project] PolymorphiX v2 (alu & steel alu hybrids)
[Pending finish] Butcher's Hook (Slipknot tribute bench in steel)
[mod2hardware] All Modding Projects by CattleRustler
[mod2software] WorklogCreator 1.0.1.7 visually build postable worklogs, quickly & easily with drag and drop