Tech Bench - Day 04 - screw holes and drillouts
got ready to score thru the side panels so I could drill out the bottom and mid platforms
after the first one
drilled out (sorry blurry)
screwed together
did the same on the other side, and screwed them together
hod to do the mid platform - I knew those weak ass 90d clamps would come in handy one day
the bottom panel depth was 1/16" or so long, so I needed some shims as I worked this part out
after getting one set of screws done for the mid-platform, I flipped her and did the rest
test fit
test fit a fan
instead of unwinding 14 1.25" screws by hand I checked my box of tricks to see if I had a 3/32 hex drive
win (unbolted the sucker in about a minute, as opposed to 10 mins)
used the dfi mobo to score off standoff holes
pre-drill scores
drilled them out 7/64 then screwed in some brass standoffs for a test fit
mobo mounted, all ok
marked off the areas that will be for cm openings and loaded whatever that thing is called... spade bit? lol w/e
began a cut-fest
booyah
next session Ill connect the dots on the ergonomic cutouts
thanks for watching
* This Worklog post was generated using WorklogCreator - Version: 1.0.1.5
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip