Tech Bench - Day 06 - work lotsa
got the case assembled to score off the L-brackets
went up to the hw store and got some stuff, including these L -brackets. scored off the 16 holes
prepped to drill out the holes
16 holes later I needed to extend the cm holes foward due to a mismeasurement previously (mock mobo vs rig mobo) scored off the lines
clamped
after boring the 1" holes...
cut both sides with a dremel, and filed the cuts. not too bad methinks
acrylic cutting time. measured off the the first cut
clamped
cuts...
what a mess, the acrylic dust covered the mdf dust lol
fruits of labor
assmebled the box
theres the L-brackets. made the box immensely stronger (note to self)
slapped on the feet
weee!
test fitted the acrylic panels...
tested router settings on some scrap
routed roundover on the top acrylic panel
needed some cubes to make hinges for the lid/top. same setup as during greenie-poo
jumped around and broke stuff including my x-father-in-law's jaw
just kidding
cube anti-spin clamp
blam
and your granny
sanded te front edges with the orbital
prepped for the mix (including respirator mask, gloves, goggles)
slapped some slop on some cardboard (havent used this stuff since Intelli build)
caked some stuff into the bad areas along the front, then used the plastic card to sheen/flatten the areas
next session I will sand it out, and the rest of the edges, then, after drilling holes for lid, its prime time
thanks for watching
* This Worklog post was generated using WorklogCreator - Version: 1.0.1.6
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip