Tech Bench - Day 07 - its something or other
put the s-o-b on her back, ready to sand
sanded out the front where the fiberglass stuff was, then sanded out the hole thing (edges)
propped with 1/4" acrylic and put the lid in place
marked the cut out areas to allow the lid to open correctly, and open beyond 90d
prepped
yeah
notches out
time for some weldon 3 cube action
fused
threw in the standoffs s I can sort out the back area
completely forgot about this, card lips need a groove
marked off
after cutting a groove
once that was done I was able to get the pci rail height and marked it off
prep to cut
ouch!
"youre a good doctor - with a bonesaw"
started dismantling the case for primer when I had an OH F ME moment, completely forgot the lid screw holes
put it back together and laid out the lid. scored the screw holes thru the cubes and drilled them out
booyah
thems alotza hardware for a simple bench
stupid ace L-brackets have stupid ace stickers on them, which I had to get stupid with, and sand them off because they are stupid, and also they are very stupid. Did I mention they are stupid?
victims aligned
pa-...
...rime-time. Felt good here, first stuff I painted/primed since Intelli
did 2-3 coats and let it sit 15 mins
black satin
looks a bit glossy since its wet but it should calm down by tomr. If its too glossy when dry I will go get flat black
I had intended to start priming the panels but of course all things always take longer than expected. tomr I will begin priming the panels, mixed in thru butcher's hook work
thanks for watching
* This Worklog post was generated using WorklogCreator - Version: 1.0.1.6
* Free Download:
http://www.mod2software.com/worklogc...logcreator.zip