Update #11
My watercooling sponsorship arrived!
Thankyou so much to aquatuning!
http://www.aquatuning.co.uk . Thanks especially to Pascal for putting up with me!
Here we go...
Black Ice GT120 lite with 45 degree compression fittings on. These things are so cool, they rotate!
More rad
Fractal Design 60mm fan
Cable ties + bases
Fillport with compression fitting
Low profile straight compression fittings
45 Degree rotary compression fittings
90 degree rotary compression fitting
Mah lovely black nickel plated compression fittings!
Bitspower T-block with compression fittings
Couple of tube clamps for the block
Momentary dot-illuminated vandal switch
Primochill UV Pink Dye Bomb
Distilled water
2 pairs of UV cathodes
Tygon 3/8" ID 1/2" OD tubing
Scythe S-Flex 1600rpm
Apogee drive top
3/8" barbs on the drive
This thing is so cool!
45 and 90 degree fittings on my custom 9300-itx waterblock
Shipment from Rapid is here, bringing with it a multitude of goodness in electronics!
Some cheap sleeve and heatshrink
500 resistors (i'm not joking!)
2 and 3 pin molex housings/headers
Transistor
Capacitor
MIC502 chip. These things are SO TINY!
No that is not a giant key!
Capacitors, diodes and potentiometers
Put some dye in my distilled water. ooooo!
Test fitted the top of the PC (fan grill, acrylic, rad, fan). The rad is literally just as far over as it can possibly go. Another 0.5mm and it would be out of the edge!
From the top
Layers
Fillport in place
Fan/rad assembly