low strife

Idle:


Load:


Apparently there is less than a 10c difference on my sigrig cooling setup (TRUE + Sythe Ultra Kaze 3000 RPM).

--Can anyone recommend me a good lapping kit, or tell me exactly what I need to get at Menards?

__________________

freakb18c1

get 300 grit / 800 grit and 1200 if possible.

try the penny mod or washer mod that will bring drop u temps about 3 - 8-c
http://www.driverheaven.net/overcloc...grees-off.html


EDIT
AI Overclock tuner: Manual
CPU Ratio Setting: 8
FSB Strap to North Bridge: AUTO
FSB Frequency: 450
PCI-E Frequency: 101
DRAM Frequency: 900
DRAM CLK Skew on Channel A1: AUTO
DRAM CLK Skew on Channel A2: AUTO
DRAM CLK Skew on Channel B1: AUTO
DRAM CLK Skew on Channel B2: AUTO
DRAM Timing Control: Manual

1st Information :

CAS# Latency: 5
DRAM RAS# to CAS# Delay: 5
DRAM RAS# Precharge: 5
DRAM RAS# Activate to Precharge: 15
RAS# to RAS# Delay : AUTO
Row Refresh Cycle Time: 45
Write Recovery Time: AUTO
Read to Precharge Time: AUTO

DRAM Static Read Control: DISABLED
DRAM Read Training: AUTO
MEM. OC Charger: AUTO
AI Clock Twister: AUTO --> test first then try MODERATE if no go LIGHT
AI Transaction Booster: AUTO --> test first then Enable later try eg 9



CPU Voltage 1,4v (depending on ya CPU)
CPU GTL Voltage Reference (0/2) AUTO
CPU GTL Voltage Reference (1/3) AUTO
CPU PLL Voltage : 1,56
FSB Termination Voltage : 1,3
DRAM Voltage : 2.20 (depending on ya ram)
NB Voltage : 1.26
NB GTL Reference : AUTO
SB Voltage : AUTO
PCIE Voltage : AUTO
____________________________________

Load-Line Calibration [Enabled]
CPU Spread Spectrum [Disabled]
PCIE Spread Spectrum [Disabled]
CPU Clock Skew [Auto]
NB Clock Skew [Auto]
CPU Margin Enhancement [Optimized Mode]
____________________________________

Advance CPU Settings:
CPU Ratio Setting: 8
C1E Support: [Enabled]
Max CPUID Value Limit: [Disabled]
Intel Virtualization Tech: [Enabled]
CPU TM Function: [Disabled]
Execute Disable Bit: [Enabled]