Need Help with my First build PC - Page 2 - Overclock.net

ed102r · 05-21-09

Are you able to get to the BIOS menu?

Crooksy · 05-21-09

So you did a BIOS update and it was not interupted, but you said it was afterwards?

What do you mean it was interupted afterwards?

ed102r · 05-21-09

Apparently this board does not play nice with 1066 ram, it will down clock it to 800. Lots of problems with this board including the BIOS needing updating right out of the box. Seems the BIOS updating is what caused your problem.

If by any chance you get to the bios, manually set the ram settings and voltage. Also try different slots with one stick of ram.

If the board was ok, then you would get beeps complaining of the video card, or the memory, or if it was not getting enough power because a power cable got nicked loose.

Or you would hopefully hear the all mighty POST beep telling you everything is ok.

If you can't get to the bios settings, then its not posting.

Fly~Boi · 05-21-09

Quote:

Originally Posted by ed102r

Are you able to get to the BIOS menu?

NO, I cant see anything at all when i start the computer, only blank, black screen. The PC is turn on but doesn't boot anything.

Fly~Boi · 05-21-09

Quote:

Originally Posted by JordanWillis

So you did a BIOS update and it was not interupted, but you said it was afterwards?

What do you mean it was interupted afterwards?

What I mean is that after finished my update and reboot the computer. Then i got the problem fro there.

Fly~Boi · 05-21-09

Quote:

Originally Posted by ed102r

Apparently this board does not play nice with 1066 ram, it will down clock it to 800. Lots of problems with this board including the BIOS needing updating right out of the box. Seems the BIOS updating is what caused your problem.

If by any chance you get to the bios, manually set the ram settings and voltage. Also try different slots with one stick of ram.

If the board was ok, then you would get beeps complaining of the video card, or the memory, or if it was not getting enough power because a power cable got nicked loose.

Or you would hopefully hear the all mighty POST beep telling you everything is ok.

If you can't get to the bios settings, then its not posting.

I'm thinking that the mobo that gives the problems with the following recommendations on my pc.
But I dont know if thats the case, cuz im not pc expert

Fly~Boi · 05-21-09

I have dissabled all the ram to check if there is any POST and it beeped and that worked just fine.

ed102r · 05-21-09

Did you try booting with one stick of ram?
I would try one slot at a time see if it boots, and also try gain with a different stick of ram just to make sure that by some bad luck that stick was bad.

IF it boots go into bios and set the correct timings and volts.

aaronmonto · 05-21-09

Wrong section.

XxScaevolAxX · 06-23-09

1- is your power plugged in?
2- is it switched on?
3- do you see a led on your mobo?
4- did u realy clear cmos, even so, do it again.
5- check internal power supplies and compatability

now all left for you to do if it doesnt work that way:
try with just the hdd0, power supply, 1xram, processor and mobo.
(maybe put fan on cpu xD)
and
add hardware one by one and check where it fails.

		Overclock.net - Overclocking.net > AMD > AMD - General > AMD Build Logs
Need Help with my First build PC

Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)