|
|
|
#1 (permalink) |
|
New to Overclock.net
|
I'm pretty new to this business but i got together a zalman 9700, 4 case fans and a north bridge fan and set about an overclock. Im aware that this chip doesn't have a lot of headroom so i'd like somebody a bit more informed to confirm its safe to run at these clocks.
asus crosshair 6400 BE 250 gts sli ocz reaper ddr2 Idles at 37 degrees and will sit at 60-61 runing orthos 214 x 16 @ 1.5 vcore (3424mhz) cpu<->MCP55 X5 NB<->SB HT speed x5 DDR2 voltage @ 2.125v DRAM timing @ 5-5-5-15-23 |
|
|
|
|
|
#2 (permalink) | |||||||||||
|
AMD Overclocker
![]() |
Temps are high, but safe. Voltage is high, but again, I'd say it's relatively safe.
__________________Nice OC.
|
|||||||||||
|
|
|
|
|
#3 (permalink) | |||||||||||||
|
*cough* Stock *cough*
![]() |
temps arent that high your good to go!
Is that your voltage in bios or after vdroop?
|
|||||||||||||
|
|
|
|
|
#4 (permalink) |
|
New to Overclock.net
|
Nah thats what it says in the bios, 1.44 after vdrop. My only concern is when the two graphics cards kick in at 100% it might raise ambient temps slightly.
|
|
|
|
|
|
#5 (permalink) | |||||||||||
|
New to Overclock.net
|
What program are you using to monitor your temperatures?, 60c is quite a high temperature considering your using 1.5v on the CPU, I'd back the OC down abit and stay under 55c load or get a better cooler, high temps + high volts = dead CPU.
__________________
|
|||||||||||
|
|
|
|
|
#6 (permalink) |
|
New to Overclock.net
|
Aye was kinda thinking that, im running orthos now monitoring with speedfan. I dropped the multi to 213 now @ 3407mhz and the vcore to 1.48v. Temp is now hovering round 58-59.... that a bit better?
|
|
|
|
|
|
#7 (permalink) | |||||||||||
|
New to Overclock.net
|
I'd recommend using CoreTemp to read the temps on your CPU, you should get more accurate results, but yeah 58/59c is slightly better, but still a tad too high, but Orthos/Prime 95 stresses your CPU alot more than gaming/general tasks, so I guess you'd probably be ok.
__________________
|
|||||||||||
|
|
|
|
|
#8 (permalink) | |||||||||||||
|
Overclocker in Training
![]() |
I would opt for a better cooler
AMD says not to push past 63C and i am inclined to agree I suggest you sell the one you have now and pickup an HDT cooler with a nice high CFM fan you shouldn't lose more than 15$ and you will have the headroom to run 1.5V
__________________
Got out of bed, could not remember my own name Condemned to walk the soil amongst all creatures wild and tame Go where I go, do what I must Crawl starving on my belly Licking up the dry dust
|
|||||||||||||
|
|
|
|
|
#9 (permalink) |
|
New to Overclock.net
|
Downloaded coretemp as advised and both cores are at 59. This gives me a 2 or 3 degrees before i run into trouble? Ano that zalman isnt the most effective cooler but the cpu temp dropped about 7 degrees after installation & damn does it look good
|
|
|
|
|
|
#10 (permalink) | |||||||||||
|
New to Overclock.net
|
The max ''safe'' temperatures AMD specified are actually 55-63c here , now you need to remember you have an overclocked CPU, which has much more than stock volts being pumped through it, so I wouldn't really recommend going any higher than you already have, you're already pushing it.
__________________
|
|||||||||||
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|