|
|
|
#2 (permalink) | ||||||||
|
Overclocker
![]() |
welcome to the forum!!!!!!!!!
__________________more info please can you put you system in your profile
|
||||||||
|
|
|
|
|
#4 (permalink) | |||||||||||||
|
Old AMD Guy, Trying Intel
![]() |
Well, that nfroce 3 150 is going to severely limit your overclocking since it lacks a PCI/AGP lock, but all you need to do is bump the FSB/HTT up in about 5MHz increments until it doesn't boot. Then, just add a little more core voltage (.025-.05volts) and then go into Windows and run a load on the system and make sure the temps don't get too high.
You may as well dump that 64-bit Windows as it isn't worth snot anyway, and usually causes more problems than it solves.
__________________
Heh, Computers... Went almost two years without any major system overhauls, so I'm treating myself ![]()
|
|||||||||||||
|
|
|
|
#5 (permalink) | ||||||||
|
4.0ghz
![]() |
200th rep point for The General YAY, by me of course...
__________________Anyways, consider buying a new motherboard and a XP-120/90 to get a better OC.
|
||||||||
|
|
|
|
#7 (permalink) | |||||||||||||
|
Old AMD Guy, Trying Intel
![]() |
DFI LANParty UT nF3-250Gb
__________________
Heh, Computers... Went almost two years without any major system overhauls, so I'm treating myself ![]()
|
|||||||||||||
|
|
|
|
#9 (permalink) | |||||||||||
|
Overclocker
![]() |
Thermalright XP-120 or XP-90. Either or, they are both good coolers that dont weigh a frikin kilogram, and can use 120, and 90mm fans respectively. If you dont mind risking your computer with a cooler that weights a kilogram and a cooler that can use 2 80mm fans look into a Coolermaster Hyper6.
__________________
"As we arrive at Espace I'm on the verge of tears as I'm certain we won't get a decent table. But we do; relief washes over me in an awesome wave." -Bateman, P American Psycho "I'm not bad, I'm just drawn that way." Rabbit, J - Who Framed Roger Rabbit? Read this: http://www.overclock.net/off-topic/1...ection-11.html
|
|||||||||||
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|