Unofficial TF8200 A2+ Thread **Updated 06/27**

[akira022]

well with the hw monitor and a 2 minute ortho test at base lvls cor 1 is at 33C and core 2 is at 30 and the monitor that came with he motherboard only checks core 2 temp. and no warning messege yet

[winginit]

If you're still having trouble, I think I would be tempted to do a CMOS clear, then load optimized defaults in the BIOS, save and exit.... and then start from scratch again.... using just the BIOS to OC.

[akira022]

how would i do that just reflash with the same bios upgrade?

[winginit]

.... no, you would just shutdown, unplug from power, move the CMOS jumper to the clear position for 10-15 seconds, then move the jumper back to the default position. It just restores all your BIOS settings to their defaults.

[akira022]

well...im upping referance clock and not have that dang message and so far so good.

[akira022]

and there is that dang warning. at 240 of the cpu frequency i dont know what the deal is with it. the temps were 35c on core 0 and 32c on core 1. It get warmer then that when i have it on auto or even normal. I dont even know where the warning is coming from...and why it only flashes on and off the screen. do i ignore it and continure or where do i go from here?

[akira022]

well...i did a 10 minute ortho in normal mode...without ocing and temps are holding at 45 on both cores and no warning.

[akira022]

i did a 12 minute ortho in auto v8temps are holding at 50c on both cores and no warning. so it has to be something im doing or not doing

[akira022]

i was thinking in my sleep last night and i remembered that when i installed the power supply my +12 plug had only4 prongs instead of 8...the manual gave instructions just to plug it into 1-4 spot. It plugged in with no problems. Would something like that be the cause me error message?

[budgetgamer]

Originally Posted by akira022

i was thinking in my sleep last night and i remembered that when i installed the power supply my +12 plug had only4 prongs instead of 8...the manual gave instructions just to plug it into 1-4 spot. It plugged in with no problems. Would something like that be the cause me error message?

If I am not mistaken there is only one way you can plug into it. And yes it's pins 1-4. This should have nothing to do with the error message. Have you tried using Google to look up more on the error message your seeing?