help oc 955 - Page 2 - Overclock.net

mike89lx · 10-18-09

Ya that is wait it is doing ...if the temp go`s over ...63c.64c...it will just blue screen me....Which is fine because I don't want to cook this thing "insurance"..lol......the water will lower my temp and then ill go from there.....is there any tips or tricks ocing my m4a79 deluxe when I get water cooling?..I mean is there anything I should or should not turn on or off in the bios?....ohh and I forgot I have not touched my nb voltage yet what is a good voltage for my nb?

jimibgood · 10-18-09

Quote:

Originally Posted by gsk3rd

It's a rule of thumb is not to go over 1.55v on air plain and simple. Not everyone is as lucky as you are jimi.

Some have air and get better temps.. That is my point. So they can exceed 1.55V.

jimibgood · 10-18-09

Quote:

Originally Posted by mike89lx

Ya that is wait it is doing ...if the temp go`s over ...63c.64c...it will just blue screen me....Which is fine because I don't want to cook this thing "insurance"..lol......the water will lower my temp and then ill go from there.....is there any tips or tricks ocing my m4a79 deluxe when I get water cooling?..I mean is there anything I should or should not turn on or off in the bios?....ohh and I forgot I have not touched my nb voltage yet what is a good voltage for my nb?

Mike. Slow down and breathe in and breathe out. As a new overclocker..DO NOT RUN OVER 55 DEGREES ON LOAD ....PERIOD.. You are taking the chips in your own hands. Get a good overclock or as high as possible with 55 or so..... Then get watercooling.

As far as bios goes, you need to read up and understand. Every system is different and what bios settings work for me may not work for you. I got my 955 stable 4GHz with my old M4A79 deluxe.

mike89lx · 10-18-09

I just wanted to see how hi I could get it and it was 3.9 on air and stable...I turned it down to 3.8 at 1.475 and it is very stable so I am going to leave it there till the water cooling go`s on..I was just trying to do some research on the mother board just to give me a better idea when I start oc it again with water.....

mike89lx · 3 Weeks Ago

OK water is on and temp went down 22c in prime95 but still cant over clock past 3.9 ghz...But I noticed something in my bios I had the vcore at 1.55 and in the bios under the "power" tab I can see the vcore voltage and it only shows 1.5 volt even if I put the vcore at 1.7volts...also with cpu-z the voltage will show the some voltage as the bios if I stay under 1.5 volts if I put the voltage past that point it jump around....could my prob be my psu? I am only running a ocz 600 watt.

dixson01974 · 3 Weeks Ago

There is a jumper for higher vcore. If you want a higher voltage then move the jumper.

mike89lx · 3 Weeks Ago

I tried the jumper on both positions....one is 1.699 volts and less the other position is for 1.7 volt to 1.9 volts and nothing....how can I test my psu to see if it is maxing out?