Turtlewrench

I too am another person having issues trying to get my 1066 ram to run as 1066. It will run 800, but if I up the voltage to specs of 2.1 it still wont run. I just get a black screen. So I have two questions about this. Oh this is a 2 x 2Gb set.

1) I had 4 Gbs of 667 ran fine. They were four sticks of mixed memory. Two by one company two by another. They are seen by the system but what would be a good soft ware to make sure that they are not defective? Note: They show up fine in CPUID correct timings just at 800, not 1066.

2) In my post screen I get a message that DDR2 800 is unplugged. Does any one know what that means?

__________________

5800 Ownerz Club

PHENOM II X2 550BE OC CLUB