TnB= Gir

Can that rad handle 2 GTX's and an overclocked quad? Oh and I hate you. I've never gotten a blue pen from petras

__________________

OmegaNemesis28

yes it can - infact I got 2 just in case but then I realized that there was no point for 2 rads in my case.

Everything is internal btw.

At the moment, Ive finished removing the internals of my current sig rig and Im prepping for WC blocks, ect. The only problem Ive hit is that a capacitor has fallen off my mobo. I managed to slip it back into place over it's 2 prongs, but I dont know if it's good enough. If I hit any problems like booting, then I'll have to RMA this piece of crap lol. Its a bomb out of its box. (Striker Extreme)

pics as soon as I have the 8800GTXs prepped.

__________________

OmegaNemesis28

I have to call both Dtek and Petras up and ***** them out. Dtek's unisink has horrid quality, I almost broke my card trying to get this piece of **** to fit. And then, Preta's didn't send me an 8800GTX plate for my Fuzion block. -.-

__________________

Syrillian

No way!...


Serious?

What was the issue? The mounting holes did not mate-up?

__________________
Silentium ~ Arcane Arts

Semper Fidelis

"Memento Vivre."

OmegaNemesis28

UPDATE - The Preparation

And to answer your question Syrillian - its in my update. Its a hard to miss cause its about 3 lines long.

__________________

OmegaNemesis28

ill update in a little while once I put batteries back into my camera.

I had a party yesterday so I didnt fully finish. And I still need coolant mixture suggestions out of PT Nuke, Distilled Water, G11, and UV stuff.

__________________

OmegaNemesis28

New Update - Part 2 of preparation (same post)

__________________

marcus000

You really shouldn't mount DDC's upside down you know.. gravity pulls the impeller out of the housing causing them to burn out a hell of a lot faster than they normally would!

__________________

OmegaNemesis28

oh.............
now someone tells me.....
then I guess I let it run till it dies?

__________________

marcus000

sorry! *feels bad*

Could you not mount it onto the floor of the case instead?
That would also solve you 90 degree tubing bend problem as well.


EDIT: and to add a 2nd kick to the balls, you shouldn't use those Gell Pads directly under the base of the Ultra's either, they're notorious for causing them to overheat!

__________________