Scratch: The Sled Acrylic Tech Bench (Thread Updated 11-24-2009)

[Jolly-Swagman]

Originally Posted by CattleRustler

nice mate

Originally Posted by superk

Very well done, gave me some ideas for a next case mod.. a tech station! rep+

Thanks Guys , and for the Rep too !!!






Will have a New Update very shortly, going to have Diner first, but I know you all have been awaiting this next Update ,,, Unveiling the Plexi,


Be Back soon,,,

[photonmoo]

A bit late for tea ain't it? hehe, only teasing.

[oliverw92]

Hope you eat fast...

[CattleRustler]

we're waiting...

[Jolly-Swagman]

heheh, sorry guy,s fell asleep on the Couch after Diner, and the Wife hasnt been well so was tending to her too!!

# Update 10-24-2009

In this Update I have wired the Power Reset Switches, LED,s for PWR - HDD activity and Mounted them,
also Mounted the PCB LED power Resistor board on its own little Sled Plexi Rails,
and wired LED Power Switch to control the Case LED Lighting,

Also did some more work on the HDD Cage , Cut out my insignia JS into the Plexi,
and Mounted in The Sled

Now there is also a Special Part of this Update and I think everyone has been anxiously waiting for, the Unveiling of the Plexi,
Well Stay Tuned as it is coming right up , see below!!!

PCB Board for Resistors Powering LEDs, and LED Power Switch



HDD Cage with Insignia Cut-out







Now lets get The Sled Naked and Unveil the Plexi


The Sled Unveiled Pics














That's all for NOW!!!


Have some more Pics on the way too of the DVD Drive - Card Reader bay Cages
Also some Lighting Up the Sled Pics too Unveiled, very soon going to have Diner first, so keep ya in suspense till then,,,,jajajaja

[photonmoo]

Sweet as, totally smexi

[oliverw92]

Very original acrylic case!

[CattleRustler]

very nice
can you post some close up pics of the bends you did, now that the paper is off I'd like to see if there is any crazing and hazing in the bends. from these pics it looks like there is some in the part where you scrolled out the JS. But its hard to tell on the bigger pieces. Either way the work you did looks really good mate. But I need to know if this bending method leaves absolutely clean bends or not. thanks if you can oblige

[Jolly-Swagman]

Originally Posted by photonmoo

Sweet as, totally smexi

Thanks photonmoo

Originally Posted by oliverw92

Very original acrylic case!

Thanks oliverw92

Originally Posted by CattleRustler

very nice
can you post some close up pics of the bends you did, now that the paper is off I'd like to see if there is any crazing and hazing in the bends. from these pics it looks like there is some in the part where you scrolled out the JS. But its hard to tell on the bigger pieces. Either way the work you did looks really good mate. But I need to know if this bending method leaves absolutely clean bends or not. thanks if you can oblige

Thanks CR,, yeah I will get some Close ups of the Bends for You,,,,

Now on to some Updates!!

# Update 10-25-2009

Today did some cable routing and management for the LED Lighting

Cable management



The Led Lighting Unveiled



Side View LED Lighting Unveiled



The Sled Tech Bench View LED Lighting Unveiled



That,s all in this Update ,, going to work on some Ideas have been cooking for some Fan grills,

Stay Tuned!!

[CattleRustler]

purty