youngmoney

i was thinking of buying one of these cases for my fisrt build but they has no side window can u tell how i can put one in

also which one do u think i should get out of these two if you know any bettter cases id like to know

http://www.2cooltek.com/DynaPower-Ha...ase-p-589.html


http://www.atxcases.com/products/pro...112&prodid=482

Syrillian

Here is a link that has some info:

http://www.directron.com/modguide.html#holesandwindows

Adding a window is fairly easy. Just make sure you do the following:

1. Tape off (blue painters tape) the area that will remain.
2. Take care when cutting so that you do not warp or deform the case material.
3. Take a small file or emery board to the edges to remove any burrs.

#'s 1 and 2 are important for a professional looking job.

I used a pair of tin snips to cut the hole. The Dremel was threatening to warp the case material (maybe the bit needs replacing).

Here is a link to some kits that are inexpensive:
http://www.crazypc.com/products/case...s.htm#lasercut

Here is a pic of the window I installed that I purchased from the site above:


Hope this helps.

__________________
Silentium ~ Arcane Arts

Semper Fidelis

"Illegitimi non carborundum"

gobygoby

I dont know anything about the cases. but FWIW, I got my case through ATXcases.com and had no problems. Spoke with them on the phone a few times and very friendly. trustworthy.

__________________

CURRENT MOD: PSOne LCD 1
NEXT MOD: ? ? ?
FINISHED MODS: * Painted Chassis * PSU Mod * Access Holes For WC Mounts * Added WC gear * Front Doors - Washer Mod * False wall * USB Christmas Light Mod * False Floor * Stealth DVD Drives