bullcrew

I went ahead and added a Zalamn fan controller to the unit today as well as modded a new plexi window with 2 120mm led fans in it. I also modded my 80mm turbo 84cfm 5400 rpm fan in the bottom of the case iaming up allowing maximum air flow to ventilate the lower chamber with the freezone and PSU.
I also added 2 blue cathodes and now putting the black light UV ones in as well.

The 80mm fan sounds like a rc helicopter , It doesnt like variable power so I put it on off and on fan conf.#2. Just bump and go when I OC now.

The Zalman is SWEET! Looks really good as well as its a good overall controller. A couple of things Id change would be a thermal limit in low/med/high in which you can set the limits to auto RPM when it hits a temp, as well as the screen is crystal clear but looking down towards it is a little bit hard to see. Other than that I have played with it and its nice....

I need some ideas on the lower part of the case with the freezone and the PSU as far as lighting and effects.


Suggest away!!!!!!!!!!!!!!!!!!!

Attached Thumbnails

     

__________________
3DMARK06 13882
http://service.futuremark.com/compare?3dm06=3365267
Pi 1M 14 sec Pi 32m 14.43.
ROCKIN A Coolit FREEZONE ELITE!

Barca

Looks mint..

SomeDooD

Very nice PC there!

I have a Zalman controller, however its the MFC1. I might get the new one soon though.

bullcrew

Thanks!
I looked at the scythe and a few others as well as had a silverstone go bad yesterday. I was a little irritated I didnt look around when I got the silverstone, I saw this one and wanted it. Then the silverstone went belly up on fan controller so "WOOO HOO!" .

__________________
3DMARK06 13882
http://service.futuremark.com/compare?3dm06=3365267
Pi 1M 14 sec Pi 32m 14.43.
ROCKIN A Coolit FREEZONE ELITE!