sabu92

just squeese the sleaving material to get it over the connector.

sabu92

BTW welcome to Overclock.net. Have fun.

dahoge

ok. what about for the heatshrink though? i have 1/2" and 1/4" heatshrink. i dont think either will fit over the connector.

-Thrilla-

does it matter if i mix up the black wires of a P3 connector, cuz i forgot to lable them

Inspire

Its always best to make a note and put things back where they came out of. I think the black ones go in the middle?

__________________

-Thrilla-

but having a 12v going into a 5v ground just doensn't seem right to me

BFRD

I do not think that the position of the black wires matter. I could be wrong, but I think they are interchangable. Just as long as the other two wires are in the right spots.

__________________
Helpful Posts (Hopefully )
Overclocker's Calculator
Photo Editing - B&W w/Color Accents

-Thrilla-

sweet i used a cheap 12v case fan to test it and it works

jpie

Hmm..It might just be me, but is there a reason why it still looks kind of tangled/messy? I dont see much of a difference in that, and just coiling the wires together. I dont know. My computers completely closed in atm (dell) so I dont look at the wiring much. Is there somewhere you can stuff the extra cables or something? Cause it looks like a clusterfluck in there..However, it does look better than yellow black black red yellow black black red yellow ORANGE (newcolor omg!)black black yellow red black black...etc..hehe


Maybe im just stupid. Can anyone show me a picture of a non organized psu cable computer? heh...

None the less, GREAT guide. I just wish there was an easier way :P

Jjangthekid

I don't think you mentioned this but where can I buy the sleeving material that you used?

__________________
PSN: Snoozey
Xbox 360: AegisFreedom