FoRmEd

Ya, I have these LED's on the way, but I was told that I need
to have resistor's hooked up to regulate the power...

Can anyone tell me if that guys was pulling my chain...
Or give me a link to the resistor?

__________________

bigvaL

It says theyre 5 V leds which means youd just take power off the 5v rail of your psu. I've never used them before but they do sell molex to led wires. It converts a molex to a tiny black 2 pin connector but you'd need one for EVERY led

__________________
CS:S Server - GunGame 100tick Ping Boosted 32 Slot: overclock.nuclearfallout.net:27015
OC Settings: 3600mhz (400x9) 2:3, 1200mhz 5-5-5-15, 1.475vcore, 2.25vdimm, 58 C load @ 22C ambients, 650/2000 GPU.

The Bartender Paradox

It depends on how many you use and how you hook them up. lets get a description of what your dooing with them and we can help you better.

__________________

FoRmEd

I cant go to far into it, becuase I dont want to break the Rules
for the "Case Mod Comp."

But I am going to be using them to light up 6 different areas in the case...

__________________

The Bartender Paradox

hmmm. since they are 5V you can run one of the 5V rail. Wire in paralel to run multiple LEDs off the same wire.

__________________

FoRmEd

I just got a brain fart... which wire is the 5v rail?

__________________

-Thrilla-

The red one

rustler753

Wrong, they are 3.3 v leds... you need a 470 ohm resistor and run them off of your 12v rail. That 5v reading you read is not what you refere to when powering your led setup

__________________
Intel Core Duo2's are amazing.

FoRmEd

LOL... alot of help that is...

Which set of wires from the PS is it? LOL

__________________

-Thrilla-

Ok those are not 5v, that's the reverse voltage, whatever it means.
It's 3.50v, and you will need resistors, unless you hook 4 of them in series and connect them to your 12v wire.