TheTurk

Planning to get 4 120's for my side panel and id like to know if ill be able to connect all 4 to one controller?????

any suggestions for fans and the controller would also be very helpful THX

__________________
Everything in my sig is for sale

Tjingsted

Before you start, make sure you controller can take the combined wattage from the 4 fans on a single rail.

Cut 3 out of 4 red wires and make them one and put some heatshrink around.
Do the same for the black wires.

Now you should end up with a single plug for 4 fans.

__________________

XAslanX

Fans:
http://www.newegg.com/Product/Produc...k=ultra%20kaze

Fan Controller:
http://www.newegg.com/Product/Produc...82E16811995016

__________________
Freedom can't be given, only earned.

My Case Mods:
Project Mufasa , Project RedDragon , Pride of Baghdad tribute , Case mod competition 2009 Project Spitfire

e6600 @ 3.7GHZ Celeron D 336 @ 4.1GHz

Monst3r

All you need is a fan controller and 3 Pin Fans, My fan controller can control up to 6 fans

__________________

LoneWolf3574

Controlling 6 fans with a 6 fan Zalman controller with no problems.

Now to just reduce the air resistance, cutting the stock grills maybe?

__________________
What's your ambient temperature? Your "to hot" cpu may not be the fault of your heatsink.
Quotes are great, taken in context and not distorted.
I'm convinced, check out 80-Way TIM Performance Review and see why
The Barracuda Validated

We Are The Red Tide

justinDA

Im using Four of these connected to this using two of these. Everything works great, it is much better than the stock 230mm fan.

__________________

AUSSIE OCN CLUB

We Are Gr33n Machine

*OFFICIAL* OCN Flight Simulator Pilots

BensJammin

I use a Vantec Nexus NXP-205 fan controller which controls 4 fans and allows 18w per channel so is fine for most fans. Best thing is that it fits in a floppy bay instead of 5.25 bays.