holtzman

I just finished my 690, check out the pics and mods and everything I did HERE!!

__________________

CM 690 Club

Gr33n Machine

iandroo888

nice! added you to list. also, take a picture of it with all components in.

__________________

We Are Gr33n Machine | The ß₤ứə Çřёώ | The Cooler Master 690 Club | OCN Headphones Club

My Sale Thread !!! Come check it out !

evil-98

heres my work rig nice thread guys

http://www.overclock.net/water-cooli...-update-9.html

__________________

iandroo888

welcome to the club! nice rig there

__________________

We Are Gr33n Machine | The ß₤ứə Çřёώ | The Cooler Master 690 Club | OCN Headphones Club

My Sale Thread !!! Come check it out !

xlastshotx

... So Un-modded? haha jk. Thats one nice rig there

__________________
Q9550 C1 - 4,531Mhz > Image > Orb

rx7racer

Yea, my wire management is horrible with this new psu, my HX520 was simple due to it being modular. The 3870 doesn't help though, the power wires just get right in the way.

I figure I'm gonna have to get in there and cut the heck outta the case to get room to run wiring the way I need to. Either that or start cutting wires from the psu

I am about to get a new mb though so hopefully I can look at board layout a bit closer and think about how to run wires.

Flower

Check this post. Note that he runs some of the cables via the little rectangle cut out next to the PSU and up behind the motherboard tray.

__________________

ignite

Just got my CM690 since the lack of cable management in the Antec 900 really threw me off (that and it was much cheaper!).

Just a question about fan placement. Assuming I'm using 4 120mm fans, what would be the best placement for them? I was thinking of keeping the 3 stock fans in place and putting the fourth up on the top of the case (and might add an 80mm fan on the bottom by the PSU). Would that be the best way to use the four fans?

Flower

When and if I get the cash I would like to get one of these cases and 4xAerocool 14cm fans. I was thinking of putting 2 on the side pannel (moving the stock one next to the PSU) and the other two on the top.

__________________

iandroo888

this is how mine is set up.

Front - 120mm yate loon intake
Front (5.25" bay) - 120mm intake
Side panel (over cards) - 120mm yate loon intake
Rear and Top - 120mm yate loon exhaust
Bottom - 120x38mm panaflo intake

as for the psu issue, uhh where would you put it? id anything, just flip the psu, fan face down.

what id suggest is replacing the rear and top ones with higher CFM to exhaust (not sure what those aerocools you mentioned does). and one on the bottom or front intaking. i dont have any of the stock ones left in my comp seeing they are kinda noisy.

__________________

We Are Gr33n Machine | The ß₤ứə Çřёώ | The Cooler Master 690 Club | OCN Headphones Club

My Sale Thread !!! Come check it out !