|
![]() |
Overclock.net - Overclocking.net > Case Mods & Cases > Computer Cases | |
CPU power cord is not long enough...
|
||
![]() |
|
|
LinkBack | Thread Tools |
|
|
#1 (permalink) | |||||||||||||
|
Intel Overclocker
![]()
Join Date: Feb 2007
Location: San Fransisco Bay Area
Posts: 1,059
Rep: 107
![]() ![]() Unique Rep: 84
Trader Rating: 12
|
k, i know i am a noob to call it a CPU power cord. It's that yellow & black 4 pin CPU power line that goes to the motherboard (from power supply). it's too short that it has to go underneath the video card and block 3 PCI slots in CM690 case.
__________________i am wonderring if there is anything like a extension adaptor that i can purchase so it doesnt block any of the PCI slots? thank you
|
|||||||||||||
|
|
|
|
|
#2 (permalink) | |||||||||||||
|
4.0 GHz
![]() |
you seriously have to look before asking......
http://www.newegg.com/Product/Produc...-006-_-Product
__________________
_____________________________________ SECOND RIG: modded rocketfish || DFI P35 DK-T2RS || Q6600 @ 3.2ghz || scythe mugen || 2 gig of PNY XLR8 800mhz 3-3-3-8 @2.3V (D9GMH) || EVGA 8800GTX || coolermaster 750watt || 2 36gig raptor's in raid 0 laptop: Asus G51-RX05: Asus P45m || C2D P7350 @ 2.5ghz || 4 gig @1000mhz 6-6-6-18|| GTX260M (8800gt) || Seagate 320gig
|
|||||||||||||
|
|
|
|
|
#3 (permalink) | ||||||||||||||
|
4.0ghz
![]() |
__________________
Start folding HERE! Quote:
|
||||||||||||||
|
|
|
|
#4 (permalink) | ||||||||||||
|
Overclocker in Training
|
try going right over the GPU. it aint pretty, but when i had the same problem of going around, i was able to barely make it by going right over.
__________________
|
||||||||||||
|
|
|
|
|
#5 (permalink) | ||||||||||||
|
PC Gamer
|
I'm surprised that it's to short, where is the actual 4pin connection on your motherboard? I was able to route mine from the PSU, behind the motherboard tray, and then out the top of the motherboard tray to the motherboard...
__________________
|
||||||||||||
|
|
|
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|