Modding Supply Sale for OCN Modders! - Overclock.net

*CyberDruid* · 10-03-08

Hi guys

I am adding a few items to my store and will be promoting them here with special pricing for the OCN Modding Community.

.032 Alumninum Hex Mesh (1/4" hex) 18" x 12" section $10 on the store/ $7.50 here.

Neoprene Edge trim (slightly different, rounder profile than the typical black rubber) $1.25/foot on the store but $1/foot here.

Buna-S Rubber C Channel (like you get from MNPCtech) $1/foot at the store and $.75/foot here.

MasterKleer 7/16" ID - 5/8" OD .$75/foot at the store and $.50 here.

I will also be listing some more basic supplies like grommets and Torx-Head screws to replace the stock factory screws used in most cases depending on interest.

Look for a sale on Shin Etsu TIM soon

PM to place an order.

smorgan · 10-03-08

Awesome CD!
When I get into case modding (which means when I get money) ill definetely be dropping by....

looking forward to seeing the Shin Etsu

*CyberDruid* · 10-03-08

Here are some shots of the C-Channel. I chose some profiles different than those other vendors carry.

This is the Buna-S rubber channel.

It's wider than some you typical see for sale but is for a 1/16" panel thickeness.

Here's what it looks like trimming out a 120mm hole.

It's fairly thin so you could put a grill or filter over it.

This the neoprene channel. It's rounder...but more like a teardrop chape.

Again for the typical thickness panel in a chassis 1/16".

And that is what it looks like around the same 120mm hole.

It's easier to see that this is "fatter" in profile than most c channel type trims.

I find this type very easy to cut and mate up seamlessly.

I've got 50 feet of each type on hand.

kennymester · 10-03-08

I used that same neoprene channel on my build and have to say its definitely the best. Works great especially for windows because most double sided tape is 1/16 thick and the channel makes the window fit flush. Great for people who don't want screw heads sticking out.