yomama9388

So you have decided to go subzero, good for you. The most important thing to having a successful subzero run is to insulate your gear properly.

Well to begin you will need a roll of Frostking (silver roll), shop towels, your cooling of choice (phase, ln2 pot etc.), neoprene sheets, and some armaflex for your pot. In the picture I have some conformal coating, it is optional but I have never needed it on a bench run.






Next, you need to take your motherboard, take off all cpu cooling and clean the processor.





After you have cleaned the cpu, you need to insulate the back of the motherboard. I like to make a little piece for the back using two pieces of frostking stuck together. Then I put my neoprene backplate on above the frostking.








After that I put the pot's backplate on the board, holding the insulation to the back of the board.








After I have my backplate on I start insulating the socket area with Frostking. I usually like to use two layers of Frostking and then a neoprene gasket on top. The frostking should turn out something like this:





Then apply the neoprene gasket which should look something like this:








If you are benching with lots of humidity, then I recommend applying shop towels to your socket area to stop any condensation that forms.





Now that you have your motherboard insulated, it's time to apply your cooling of choice. For thermal paste use Arctic Ceranique or another WHITE thermal paste. Other thermal pastes will freeze.





And my cooling of choice,





For the pot insulation I use armaflex pipe insulation





After putting the pot on the board with the bottom piece of insulation tightly secure the pot.





Then you can put on the top piece of insulation to finish!





After that just put your system back together and get ready to bench





Hope this helps some people give subzero a try, I have never killed anything do to condensation using this insulation method. Any tips on improving this guide is much appreciated.

__________________

Dillmiester

Excellent guide.

Wankerfx

Doubt many people will ever go subzero on this forum... but excellent job nonetheless. Be sure to add that dielectric grease or vaseline should be used in the socket for a more permanent setup (phase change). I also like to coat the top and bottom of my motherboard with nail polish.

__________________

yomama9388

Yeah I didn't include dielectric grease or conformal coating because this is just insulation for short term benching.

__________________

mega_option101

I have always wondered how much prep actually goes into this, so I thank you for the guide. +

I was also wondering what the run down of the price for all the equipment is? I need something new to play around with Water-Cooling is so passe lol

__________________

Join Overclock.nets
HWbot team here!

yomama9388

Hmm, well pricing really varies a lot. For all of the insulation I have, I spent around $50 although a lot of it is used for insulating other things. For pot prices, it really depends on what you are looking for. A good aluminum pot can be had for around $100 and a copper pot will cost a lot more than that.

You should definitely give it a shot though, dice is really fun and isn't to expensive.

__________________

mega_option101

I'll definitely have to give it a shot Now if only I wasn't broke due to University Looks like I'll be starving myself to save up for this Now I just need to make myself a tech bench

__________________

Join Overclock.nets
HWbot team here!

Mmansueto

nice guide. +rep. thanks man. i am considering doing phase right now, and this helped me visualize what i will need. Thanks.

yomama9388

Yeah for phase just remember to use dielectric grease in the socket and perhaps conformal coating on the board depending on how humid it is where you are.

__________________

Rick Arter

Great guide thinking of going DICE soon and this really helped out on how to insulate the board.

__________________