Specs are below...
I'm trying to set my MEM past 860 in the bios, but I can't seem to get it to boot. My FSB is at 1120, vcore at 1.365. Vdimm is at 2.1V, the highest allowed in the bios. Any suggestions, I can't seem to get higher than these figures.
They can range from just using a pencil to soldering resistors to connect to different objects.
An example was performed on the Intel "Bad Axe". It's a sucky Intel motherboard to begin with, but if you can mod it, it will most likely dominate anything out there. (Staple mod: where you put conductive material IE: staple to connect to objects)