Overclock.net banner

dtek gfx 2 + unisink mounting

259 views 4 replies 3 participants last post by  nub 
#1 ·
i can't post pix because im on my tablet...

i mounted the unisink with the supplied pads and screws.

so now the waterblock just scews into the unisink?? the blocks scews cant pass thru the pcb so ii used the same screws as the unisink.

but the block seems to float a bit in there. i cant tighten it ant more to the sink but it rotates a degree or two in thar 'pocket'.

what am i doing wrong??
 
#3 ·
is this a good setup? I wanted to put my alpha dog in sli mode with 2 of these

I got the pump, rad, res for it just need the heatsinks and unisink for it
 
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top