Posts by Jobotoo

Quote:Originally Posted by kevingreenbmx make the guide good enough and I will add it to the Modder's Manual What is this Modder's Manual you speak of? I would like to get my hands that.

Quote:Originally Posted by kyismaster heres an idea: dont mind the trashy writing, i was gonna paint it lol. Thanks! I think I get it. I'll go over some videos and see if it gets clearer.

Quote:Originally Posted by Demented If you get MDPC shrink, you can get it pre cut, which is the best. Otherwise, Lutro0's videos have a easy way you can make a jig to cut it right every time. Rgr that. I'll be watching his videos...

Quote:Originally Posted by Demented So far: I think it looks a little better(tried to hide the writing on the shrink a little better), but this shrink is of a larger diameter, so while it might look OK, the strength isn't...

Quote:Originally Posted by Lutro0 You could, however the point is to use the heatshrink as the holding agent, the "melting of the sleeve" is just a tiny tiny bit to help with the inserting of the cable into the connector and give...

Quote:Originally Posted by Lutro0 Please keep in mind one of the finer points of using heatshrink it to be able to melt the sleeve underneath a little to make sure it has a good bond and stays strong. So keep this in mind. Could you...

LOL!!! I registered, filled my cart, and ordered . . . and then it went offline again . . . But I got my order in!

Thanks!

Quote:Originally Posted by ehume PDF Startup: 530mA Running: 123mA Best sleeving Good heatshrinks I tend not to use controllers. Where I do, they are single channel and sit inside my case. Bitte Ordered some sleeving and...

I have 36 GT fans with three wires. Which MDPC sleeving should I get to fit all three wires inside, and what size heat shrink (that will go over female 3-pin fan connector)? If I am going to remove the wires from the fans and re-solder...