Posts by musicfan

Also beware that some dyes can be incompatible with certain tubing brands as well. You may want to see this thread where the Mayhem's rep comments around post #19. Good luck.

Quote:Originally Posted by thetrystero Ok. Let me step back a bit here. How much noise does the x2o v4 pump actually make? Would it be noticeable at all running at full speed the whole time?Most report no trouble running a healthy...

Here is Martinm210's experience using a DDC on a budget (Sunbeam) 30 Watt/channel controller. Note the narrow operating range with the ability to deliver only 11.21 volts and minimum of 10.02 volts. It also got hot. Lamptron generally...

I have an XSPC 120.4 radiator on the back of my haf 932 case. Works great. I did not put it there for performance but because I have a 120.3 inside, 2 pumps, etc. and no more room for radiators. I use a Koolance bracket. Some use REALLY...

There is a nice comparison table at Sidewinder Computers. If you can afford it, consider the 35x with the PWM so you can control speed easier, which affects both noise and heat. But all the Laing pumps will work fine for your loop. Good...

I have Bitspower compressions and would blister and lose skin on the middle joint of the index finger of the right hand - more thumb side than pinkie. Now I cover that area with a strip of regular thin (not padded) moleskin. The cotton...

You ask is 1 rad enough? I reply, "not for me unless it was much bigger than 120.3" The 7970's are pretty hot around 230 tdp each. So I would not run those and your CPU on a 120.3. You may get away with it if you have powerful fans in...

With the same stock kit fans, the 120.3 RS radiator will cool more than the 120.2 RX radiator. I do not own an AMD fx 4100 so can't give you advice on temps except to say that a 120.3 radiator is usually adequate. At worse you would...

One more... http://www.newegg.com/Product/Product.aspx?Item=N82E16835214034

For a typical low-restriction CPU, VGA card full-cover, and 2 rads, the XSPC 750 pump will be fine. There are some blocks & rads that are very restrictive so buy low restriction components for best results with that pump. See Martin's...