Posts by Nipples

ok, I had a feeling this was the case but needed to make sure, Thanks for the help.

Thanks for the reply, I was thinking about how the current on the rails work. As load increases so does current i assume. With that would i design a circuit to handle 0.5A? I'm thinking of and led and/or fan controller. I think i will...

Hey, I want to make an Led circuit for my PC. My PSU says that the 12V rail can go from 0.5A up to 30A. If i'm to make a circuit, How do i decide what current to use when planning?

Ok thank you for that, was just bit worried about damaging my ram. Though i just changed it back to default settings and it's still the same so I'm not going to worry any longer

Hey, i just got some new ram today ( corsair Vengeance 1600mhz which i had to force in bios) and i started hwmonitor and noticed that VIN8 was at 1.704V. What is VIN8? is it related to my ram?

Hey, your Phenoms max temps are 62C but you should try stay below 55C for both your CPU's protection and stability ( temps do matter ). If you have CPU-Z check the revision, if it's C2 you've may have hit your limit unfortunately.

my Deneb (stock 3.2GHz c2) I clocked at 3.7Ghz which I used Daily, Though cooling problems have since kicked in.

for the moment, just cant see a way to solder it.

nah, it's gone. can't even see the pad too many components to see where the track goes. Thanks for your help guys, much appreciated

iv found a little spot just back from it tried soldering to that after scraping of the insulator but seems to be a no go. will look for more potential spots and try get some clearer pictures.