Posts by Kobiqoi

Ok so pulled it out an I think iv got it the p1 wasn't all the way in which I could not see as it was at the roof of the case and it under the heat sync ( worst placement ever) BUT is have discovered a new problem the main board control...

I've tried looking up the 16 guage stuff and the conclusion I have come to is that any normal PC cord will work because there the only cords that fit as for the power I can see no fisical switch on the psu (haven't taken it out will...

my specs are Intel SC5600BASE Server Chassis 5U Rack, 670W with a ASUS Z8PE-D18 Server Motherboard my cores are 2x Xeon E5645 and Kingston 48GB (6 x 8GB) PC3-10600 1333MHz Registered ECC DDR3 RAM, Dual Rank x4, Thermal Senor - CL9 and a...

Ok so I finished building my server last night and every thing was looking good until I tryed to turn it on I plug a power cord in (being that its an American psu rated for international use but saying its needs 16gage wiring which as...

i just got 2 noctua nh-d14's and in the Manuel it says for lga1366 that i need to remove the stock back plate i'l post pic's but i cant see how i would remove this if it is what i am meant to remove and i tryd putting the back plate on...

Hi i was think of using an SSD for my server boot drive and was wondering how big will i need it as i'l be having 144GB's of ram and was wonder does a server operate like a normal PC where i creates a page file mirroring the amount of...

ok its 180mm's p.s took more then 5 mins had to stop and stroke the dims there so shinny...

OK i was wondering what would be the best heat sync's for my server as i have no budget (unless its a $1000 per fan......).i'm using a Intel SC5600BASE Server Chassis 5U Rack, 670W and an ASUS Z8PE-D18 Server Motherboard and my cores...

hi i'm looking for a switch any switch that will take 3- 4 Ethernet cords from a modem as outputs (like bandwidth) and the rest input that has 16 or more ports i can find ones that have 1 output but can seem to seen any with 3-4 would...

pic of the PSU info