Posts by Atlantida

My experience with CPU PLL Overvoltage with my new build is that it definitely allows me to get passed 4.8ghz, but I get about three boot cycles before it posts, regardless of any voltage increase or decrease. With it disabled, 4.8ghz...

I can't enable 1T command rate at anything higher then 1600. Any idea's? Bios and CPU-Z says 2T, even if I set it manually.

Anyone else getting cold boot restarts with F1/F2 codes when PLL overvoltage is enabled? I get about three restarts before the bios screen appears, then it finally gets into windows. 100% stable once it gets to windows. It's just...

Sweet. I never know how to read these scores properly.

Hey guys. Is this score any good for two 128 M2P's in raid 0. It's an Intel z68 sata3 controller.

I just used a q-tip and a drop of dish soap. Lubed up the outer tubing (just the length of the compression housing), and it made the job of tightening the fitting over the tubing a hell of a lot easier, especially when it started to...

Dam that's going to be an insane build!!!!

My PC does this same thing every so often. Push the power button, or Shut Down through start menu... screen goes blank, HDD's spin down, no signal to monitor, but the fans, lights, etc.... stay on. Are you using a battery back-up...

I think I'll be flushing my loops sooner then later to avoid any build up on the block pins. TY for all the info.

I noticed after one leak test, my black Primochill tubing started to show signs of plasticizer (I'm still not clear exactly what specifically the term is). A uniform dark white film forming inside the tubing. This was after less then...