Posts by MORE SPEED

You'll have to be careful with the fan clips on the NH-D14. I used some heat shrink on it, but electrical tape would do the same thing, otherwise it'll come in contact with the back of the graphics card. Don't worry about it if you are...

Crossfire 6970's? A 650W would be pushing it, better to be safe with a 750W.

Looking for an exhaust fan for this case, any good suggestions? I've been looking at the Scythe GT AP-15's/AP-14's, as they're supposedly quite quiet.

With a Maximus V Gene and a 7850, an NH-D14 fits pretty much perfectly. All I had to do was wrap some electrical tape around the fan clips, which even gave the GPU a bit of support . If you have a card with a backplate, all you would...

Quote:Originally Posted by Brightonclock Hi all, Well I finally got all the parts for my TJ08 build, but have encountered an issue, maybe you have seen itbefore and could help, I'm a bit mystified on these and am running out of...

For any of you watercoolers, check out XSPC's new res. Should go with the TJ08 pretty well. http://www.xs-pc.com/slider/d5-dual-bay-reservoir/

Quote:Originally Posted by ShodanMarcus He blew up his card from too much voltage I'm pretty sure it didn't "blow up" infact, he's using it now in crossfire. The reason why it didn't work was because he flashed it with a different...

Is the actual cooler touching it or just the fan clips?

Would it not be better using two 45 degree fittings between the GPU and rad?

Quote:Originally Posted by FZMRACERX  [[SPOILER]] BuildCPU: I5-3570K (XSPC Rasa Water Block)Mother Board: ASRock Z77 Pro4-MVideo Card: Evga GTX 680 (EK FC-680 Water Block)Power Supply: OCZ Fatality 1000 Watt (Sleeved)Ram: 8GB Corsair...