Posts by 02ssei

I have a 140mm Akaska filter I'm going to put on my lower intake. It's a fine metal mesh with a rubber gasket around it so everything is really solid.

However you filled it you can drain it with a syringe and some tubing. That's how I do mine because I didn't like how the mayhems pastel would settle at the bottom of my drain tube.

Looking good. I like how the fans match the heatsinks. Whenever I see bitspower compressions it makes me wish i went with them instead of Monsoons. Not that i don't like the monsoons, i just think the bitspowers look cleaner.

Dang, a lot of work in that car. My buddy just sold his Supercharged E92 M3 for to get an Audi R8. That car sounded awesome. Back on topic, has anyone had any problems with the card reader in this case? I tore my setup down and rebuilt...

Been running clear Primochill Advanced LRT since November 10th. Tore down my loop this week for a few changes and still have clear tubing. My mayhems pastel was settling in my drain tube, eliminated the low point drain tube to prevent my...

Quote:Originally Posted by nleksan I would think you could get away with just adding a structural brace or two, either a single piece of 1/4-1/2" thick x 1.5-2.5" wide aluminum or steel bar at an angle bolted to the rear of the MB...

Quote:Originally Posted by kgtuning What like this? much stiffer but I will using aluminum bracing like nleksan mentioned. Yes, like that. That's what I'm thinking about. Now that my build is back together it's not as bad bit I'd...

No but when I move it I'm not a big fan of how much it flexes. Now that I know I don't want to put watercooling in my XB I'd like to make my switch more sturdy. Maybe I'll post a video once I get it all back together. I think taking the...

Has anyone tried to stiffen their switch 810? I recently bought a HAF XB to play with and was amazed how rigid it is even with no side panels on it. My switch can flex a ton. I'm thinking about drilling out the structural rivets and...

I started to build my XB today and discovered the "C" hole in the mobo tray is too big and not threaded to hold a stand off. Kind of annoyed as my Switch 810 is torn down and now I'm stuck until I get a new mobo tray. What's the best way...