Posts by DarkHayZe

Quote:Originally Posted by PCModderMike Wow that sleeved tubing is nuts...the more I see people do it, the more I wanna try it myself. +1

Quote:Originally Posted by mironccr345 ^ If so, How do I contact that person? PM?

Quote:Originally Posted by quakermaas  If it was me, I would leave the cards the way they are (air cooled), until you get the blocks for them. What you are suggesting there, sounds very jimmy rigged and asking for trouble. Use the...

Quote:Originally Posted by Krahe They seem pretty accurate to me, I always have hardware monitor showing on a second screen and can tell from that what the FC will show and the outside one matches a barometer temp display that the...

Quote:Originally Posted by Krahe I'm only using 3 sensors, 1 taped to the side of my pump, 1 for inside case temp and the third hanging out the back for room temp. The only down side to the touch is it can be a bit fiddly on manual...

Quote:Originally Posted by Majin SSJ Eric I plan on getting the Lamptron Touch fan controller as well. Where do you guys mount all of your temp sensors? Does it really matter or are there specific areas of the loop that you need to...

Quote:Originally Posted by Krahe np, I'm trying to find the spec sheet that came with my Lamptron for ya but having no luck, I'm a messy bugger I have the resistance and ohms for the Touch, according to some CS that barely speaks...

Quote:Originally Posted by Krahe My bad, cant see why it would matter tbh, the bitspower ones are probably the same just wrapped in a G1/4 fitting. I just remember reading somewhere that you dont want to mix the resistance and ohms...

Quote:Originally Posted by Krahe I have one of the Lamptron ones in front of me mate and pins look exactly the same, you should have no problems at all. I understand that the pins are fine, its the resistance and ohms and what not...

Quote:Originally Posted by mm67 Resistance of sensor is 10k Ohm when temperature is 25°C, I think most temperature sensors used with PC's are like that ahh ok, thank you So these from bitspower should work Bitspower G 1/4" Black...