Posts by pilotter

this is what I have at the moment waiting for haswell.... I did some calculations; system will be watercooled. front intake 2 x corsair AF QE 2 x 67.8=135.6 CFM bottom rad monsta 4 x corsair SP PE 4 x 62.74=250.96 back exhaust 1...

Quote:Originally Posted by phillyd If you go with the dye, Mayhem's Pastels are great! Idk about bleeding or flow meters, but for fans, if you have two 140's in the front and one fan intaking from the bottom, you need more than one...

thanks, simulation I use it for is FSX. Not high demand on fps usually around 30. Scenery colour is to be correct. I see on the review that colours are ok.

good day looking for a good monitor for use on simulation games. 27"and 2560 x1440 . How is the Asus PB278Q.? I like to use track IR. Will it be ok or to much ghosting? How are the colours? I will use the screen near a window, is...

When and were can I buy this in Europe. Hopefully in the netherlands..

Quote:Originally Posted by Electrocutor You would base fan speed on (rad water out - ambient), not rad in. - There is no reason to run the fans at all if this is 0C, even if the rad-in temp is higher. stupid me, that's what I...

Quote:Originally Posted by Electrocutor It is. (rad water out - ambient) still bases fan speed on water temp, but includes ambient because your water can never go below ambient. This way, you don't have to load different profiles...

thanks, need to dig a little bit deeper into this; I always assumed it was best to have rad fan speed according water temperature. Then Case fans according mobo temperature. Flow of pumps ( I have mcp35x2) on normal speed because this...

Quote:Originally Posted by Electrocutor If it were me, I would be sure to at least have the following: 1 at the water intake before the two rads 1 at the water outflow of the two rads 3 at the rad air intake (spaced out) - the...

Right, I have time to think about temp sensor placement.... Five bp water temp sensors will go in the loop. Most likely 1 in the reservoir, and the other four in the in and outlets of the 2 rads. But I also have 6 air temp sensors from...