Posts by L4dd

Yes.

My Lachesis would do this if it needed to be cleaned, so I keep it as clean as possible. If you can blow clean air onto its sensor, it should be remedied until it becomes dirty again. Also, using the back of my hand as a surface remedied...

The 6300 has potential, I like your choice!

Quote:Originally Posted by phillipjos its this one http://www.asrock.com/mb/overview.asp?Model=M3A770DEYour motherboard seems capable of supporting your unlocked 740...

Quote:Originally Posted by phillipjos BTW I am just using a p4 power plug do the have an 8 pin plug adaptor?,could be not enough juice to cpu?That should be enough power if your motherboard does not use it for other components, but...

Quote:Originally Posted by MacLeod I picked one of these up at Best Buy today for $57 off an Amazon price match and at first I didnt like the sandpaper texture. I have and LOVE the Deathadder 3G and was used to its smooth texture...

All of those are dark except the Goliathus. Can someone post if they know that it would be the best of those, or would a plainer pad like the following linked one be...

Quote:Originally Posted by xd_1771 @ Schmuckley: That was the MA78LM-S2H, this is the LMT. So, that "high fail rate" may be a mislabel. On the other hand, these aren't high quality VRMs for a 4+1 phase.I neglected to state that my...

I have had my x4 C2 Deneb at 1.375 (1.360 during load) volts via its B.I.O.S. for its cores at 3.222GHz and 1.275 volts via its B.I.O.S. for its uncore/C.P.U.-N.B. at 2.215GHz with my old MA78LM-S2H that has but 3+1 phases and no V.R.M....

Quote:Originally Posted by phillipjos  Those look good, but a meter might give a more accurate reading. Does anyone think that this P.S.U. might be dropping too many volts under a load, or is this video card overheating? When...