New Posts  All Forums:

Posts by Slaughter

This is my favorite Steam: http://steamcommunity.com/id/Slaught3r Thanks Gappo!
Followed. Name: SlaughterHause
Quote:Originally Posted by jdm317  Thank you for the reply, both of you. I ordered the FX PRO. If I have to hurry, at worst it will just look sloppy, and I can trim edges. If I miss something I'll just start over, but I think it...
I generally use FX PRO and like it but i often find that i could use more time to finish pouring before it starts to solidify. This time around i picked up medium as i intend to prep a few boards.
Quote:Originally Posted by Mr357 Found a Koolance V2 for $100 from a guy on [H]ard Forum. It shipped today, so I should receive it and have plenty of time for the HWbot competition Thank you for buying that pot. I've been eyeing...
Quote:Originally Posted by Gunslinger. I received my replacement late last week, it worked fine with the stock cooler. It promptly died as soon as I installed the EK block on it again though, so I'm back where I started. Is there...
Check here for a distributor near you: http://www.smooth-on.com/pages.php?pID=105 I get my stuff from a sculpture supply store in Toronto.
Hmm.. I wonder if the slow is a bit easier to work with.. I use the FX-Pro but it doesn't give you a lot of time to play around. Benefit of the pro is the 40 minute cure time vs. hours. Great video by the way!
Thanks for the updates and all your efforts!
Quote:Originally Posted by BonzaiTree Well I wasn't bringing it so people could take it home, I would bring it for the event. Though if there's leftovers I wouldn't care. And I know there's not much interest, but would rice or...
New Posts  All Forums: