Posts by Mattb2e

It could just be the TIM between the die and IHS that is limiting your performance. Im not seeing any better temps than I was getting with an Antec Kuhler 620, however, I am able to run the pump and fans at 15% in speedfan which makes...

Quote:Originally Posted by BramSLI1 No, the minimum speed that the pump will run at is about 1200rpm. You can play around with the settings to determine what gets you the best performance.oh ok, so is it safe to assume the minimum...

What is the minimum suggested pump speed for the H220? I have it set to 15% in speedfan which yields about 1300rpm, is that too low?

Here is my rig: Just bought 2 more Helix fans today for push/pull. I know its not necessary per say, however, these are much quieter than the 2 Yate Loons I had on there previously.

Make sure your pump is actually running, I had the same kit and the pump failed after 1 month of use. My CPU was throttling at 105C.

I want to verify that I am understanding PWM fan/pump control, as it applies to my motherboard, correctly. With my motherboard I am given two values that are adjustable. I am given a fan target speed (range of 1-10), and a target CPU...

Quote:Originally Posted by Sp33d Junki3 How warm is it? Are you using the HD cage fans to bring the air from the front, as the front 200m fan lacks enough airflow to push through the HDD cage. I am not using the cage fans, as the...

Quote:Originally Posted by Skullwipe When you switch from exhaust to intake don't just focus on your CPU temperatures, look at your GPU and Chipset as well. If either of those increases significantly you have an exhaust deficiency...

Quote:Originally Posted by Sp33d Junki3 That gap wont affect the amount of dust as you have pushing towards top. I am now (pushing towards the top), but I have been advised by a couple of folks to switch the flow of air from exhaust...

Quote:Originally Posted by Sp33d Junki3 Didnt like the Demiflex, very restrictive and very little difference in dust. What you can do in your case, is get a bracket that would screw the length of the existing 230mm mounting...