Posts by beldecca

Wish on one of them they allowed for WC pass through - especially with the over=CPU-power supply.

Ok, now that I'm out of the hospital, I've answered all PM's sorry for the delay

Messed up the case during modding. Going to put parts in an matx case for the time being. Need to get some cash before I can try again.

Ran for about 8 hrs. Not a drip. Moved feet for external fan/rad rig out a little more and switched fan orientation (so cords go off the other side) and made a power cord pass-through. Now have to get ready for work tomorrow. Hopefully...

Heard some air / surge noises durring the first 30 sec or so. Lasted for just a split second. So continued with the trial. had a bunch of micro-bubbles. After running for 10-15 min everything sounds good. No drops or leaks (yet).

I was able to get a few more bubbles out doing some Case Yoga. Now its running its first 10 min cycle to work out micro-bubbles etc.

I've heard that the MCP35X pump from the Apogee drive can be a little loud running at full speed. Since I'm doing leak testing & removing air, i'm just jumpering the power supply (rather than putting it on PWM) I've been running it for a...

Here's the loop in question - notice how the top two lines go outside of the case for the top rad (case is a tj08e) Don't think there is a way I can get water line below the inlet of the pump in this case (well, without really trying).

So, how can I tell if the pump is dry / has a bubble in it?

Have a new loop all installed with nice black tubing. Only thing is, I'm not sure if I have all the air bubbles out and the apogee drive 2 CPU block is primed. I've only used a Koolance pump (d5 before) with clear tubing where I could...