PaRaDoX

Okay this is a odd layout and cannot be Voltmodded with a regular 7600GT voltmod
if you are trying to voltmod a regular 7600GT please see Born2killu's guide here

Okay, tools needed

*multimeter
*Pencil
*Isopropyl alcohol 85% or better


First things first. Clean the back of the card off so our pencil leaves a good mark.

Then take a multimeter and measure these two points and there corresponding resistance

Click for bigger image.
STOCK
1.375v GPU
1.8v Mem

here is what i did to my card
1.455v on the GPU by lowering the resistance to 380ohms
dropping the memory resistance from 590ohm to 515ohms gave me 2.05v mem





THIS WILL RAISE YOUR TEMPS UP 15-20C WITH A GOOD AFTERMARKET COOLER. IF YOU ATTEMPT THIS WITH A STOCK COOLER IT WILL RAISE YOUR TEMP UP ABOVE 80C

overclock.net and PaRaDoX are NOT responsible for what you do to your card

TheSubtleKnife

woot for PaRaDoX!

__________________

rottenotto

That's killer, Dox! Any idea if this will be the case with the evga Ok version, or will the standard volt mod be better?

__________________
http://www.overclock.net/specs.php?d...system&i=10644

North Carolina Overclocker

PaRaDoX

Well i bet it's not the same as this card so try the regular one first and see if the bits and bobs line up

PaRaDoX

whewt it got stuck! added a better image, too

RuSo

uh oh.......im afraid i am gonna wreck another 7600gt (xxx this time) with this, my old one died at 760/1600..........lol

PaRaDoX

Lifetime warrentys rock dude.

RuSo

do you have the samsung modules on the card?....if so,here is some extra info on them, look to the numbers printed on the memory of your card

http://www.samsung.com/Products/Semi...24qc_rev15.pdf

PaRaDoX

I used AS ceramic to hold the RAM sinks on but i'll look around for them

Lyoko

If I paired a VF900 with my TEC like I did with my CPU and Freezer 64, temps should be in the mid 20's and load in the low 50's. The problem is, I can't get a vf900 since its too expensive and my TEC in between makes it harder to get the screws on.