Carni4

Well, the ram cooler comes with thumb screws and normal screws. So first I had assamble the ram cooler with the thumbscrews. Installing it was pretty easy. Just clamb it around the white memory retention thingies and screw the thumbscrews tight. But then I tried to insert my 8800 again and found out I would fit because the bottom thumbscrew was in the way. So I had to remove the ram cooler again. Replace the bottom thumbscrew with a normal screw and screw it on tight(because I clouldn't tighten a normal screw while its in the case. Than latch the bottom clam of the ram cooler first, them the top one. And then fasten the top thumbscrew. After that my videocard could fit just. One the screws of the 8800 cooler is actually touching the retention thingy of the ram cooler. A good spacer to prevent shorting out my gfx card

__________________
e6400@3,4GHz | Team Xtreem DDR2-800 @ DDR2-1160 | Cheap way to cool your 8800 | My buildlog